Remember, when you run wiring.. Especially outside the car.. best to put it in wire loom. Not only does it protect the wore.. it Looks so much cleaner! ... See MoreSee Less

A very productive day was spent running nearly 100 feet of wire. Four speakers were installed in the front, with two more to be installed. Approximately 90% of the power and ground wires were routed to the fuse panel. To ensure ease of servicing, every wire is labeled at both ends. Once all electronics are received, the remaining wires can be connected to the fuse panel, and all leads can be safely bundled. Notably, all wires are solid runs from the fuse block to the device, eliminating the need for piecemeal connections. This replica is expected to provide years of satisfaction for Michael. ... See MoreSee Less

+5

Here's a Question i am surprised more don't ask.. " how do I fix my headlights, they won't open after I Installed the new Bumper" the front lip of the bezels has to be removed, and this is on 1982-1990models. Takes a little time, and elbow grease. Dremel or other small cutting device, 120grit,220grit,320grit sandpaper, a sanding block and a vice help make it easier. Once finished, primer and paint with a Satin black ( they werent gloss from.factory). will be adding this content to the FAQ page as well ... See MoreSee Less

+2

Hello Builders and Fans. A Quick message. In the last 10 years, i have worked hard to Earn the trust and respect from a Huge portion of the Community. I always look out for You the builder, regardless of monetary gain. And i am Honored to help Each and every one of you, Past, present and future. So i wanted to offer this. One of the best things to hit the market since Alessandro released ZA electronics, is the Season 4 Pedal from Michael Baccari. he has looked at every angle, and added some never before considered. If you have wanted a S4 pedal, THIS is the time to get it, and Baccar-i customs is the one you want to get. First, just 2 wires, Pos and Negative, That's it! 3 Demo modes for shows. Now we all know that the lights moving when pushed is a must right? Well the Baccar-i pedal has Two ways to assure the happens! We all drive differently.. some with our whole foot on pedal, others just the tip of shoe. The first method, is a Gyro-meter circuit, which will make the pedal lights move up and down going off how much your pushing it and making the pedal tilt. But what about us "toe" drivers.. the Gyro wont work, so Michael designed a 2nd way to trigger.. and that's using a Hall sensor, very similar to a Reed switch. Essentially, a magnetic switch that allows the pedal to know its moving without the pedal tilting! It comes with a magnet that you would place on the floor of the car, and the pedal senses how far it is from that. close it gets, the more the lights react You can control the tones, the Volume, & sensitivity! And, all of this is controllable via a App on your phone or Tablet! Shoot me, or Michael a message if you are ready to buy. 4 are boxed and ready to ship as of the time i post this. $499.00 Shipped to your door. You will not find a better option anywhere ! ... See MoreSee Less